Toshiba CS3950D - Manual (Page 8)

2
D4133738B
4. OPTION UNIT
(1) DC SYNC IN cable ············Model name : CPRC3700 [2m,3m,5m,10m]
(2) Camera adapter ···················Model name : CA170
(3) Camera-mounting kit ············Model name : CPT
*Contact your dealer / distributor for details of option units.
*Conformity of an option part and EMC conditions
About the conformity of EMC standard of this machine, it has guaranteed in the
conditions combined with the above-mentioned option part.
When used combined parts other than specification of our company, I ask you to have
final EMC conformity checked of a visitor with a machine and the whole equipment.
5.
OPERATION MODE
(1) GAIN selection (Camera rear-panel SW)
Switches sensitivity setting
(1-1) FIX ------------------- Factory-prefixed gain
(1-2) MANU --------------- Gain is adjustable via the manual gain potentiometer (M.GAIN)
(2) TRIG selection (Camera rear-panel DIP SW)
Switches TRIG input signal polarity used under RTS mode
(2-1) POSI------------------ Positive polarity (rising edge detection)
(2-2) NEGA---------------- Negative polarity (falling edge detection)
(3) RTS (Random Trigger Shutter) exposure selection (Camera rear-panel DIP SW)
Switches light exposure mode under RTS mode
(3-1) FIX mode ------------ Rear DIP SW
Exposure-time control via rear-panel DIP switch
(3-2) PULSE W mode ---- TRIG signal pulse width control
Exposure-time control via TRIG signal pulse width
(4) Shutter mode selection (Camera rear-panel DIP SW or TRIG signal IN [Automatic])
Switches shutter mode
(4-1) NOR mode ---------- Normal electronic shutter
Exposure control via internal sync signal
High-speed shutter: From 1/100,000s through OFF (12 position)
(4-2) RTS mode ----------- Random trigger shutter
Exposure control via ext. trigger or ext. sync input
Timing charts are shown below. (TRIG timing: Positive)
Notes: * RTS selection is automatic with TRIG status
** Neither under FIX nor PULSE W mode, RTS doesn’t
work if Electronic shutter speed SW is set in OFF
position.