Electrical installation – Thermador MEMC301 User Manual

Page 13

Advertising
background image

English 11

Electrical Installation

All model ovens on the front cover are dual rated, designed to be connected to
either 208/240V AC, 60 Hz, 4 wire, single-phase power supply.

The electrical supply should be a 4-wire single-phase AC. Install a suitable conduit
box (not furnished).

Important: Local Codes may vary, installation, electrical connections and
grounding must comply with all applicable local codes.

If local codes permit grounding through the electrical supply neutral, connect both
the white neutral wire and the bare ground wire from the oven to the white neutral
electrical supply wire.

Electrical Connection

1. Connect the red oven wire to the red electrical supply wire (hot wire).
2. Connect the black oven wire to the black electrical supply wire (hot wire).
3. Connect the white neutral oven wire to the white neutral (not bare ground)

electrical supply wire.

4. Connect the bare ground oven wire to the bare ground electrical supply wire.

The conduit cable, where connected at the oven, swivels. Rotate conduit cable
upward (or downward) and direct through hole prepared in cabinet to attach to J-
Box.

To facilitate maintain serviceability, the flex conduit must not be shortened and
should be routed to permit temporary removal of the oven.

Model

Circuit Required

208V, 60 Hz

240V, 60 Hz

M271, M301

25 AMP

30 AMP

ME301, MEW301
ME271, PO301,
POD301, DE301,
DEC301

30 AMP

30 AMP

ME302, MED302,
ME272, MED272,
PO302, POD302,
PODC302, DE302,
MEM271, MEM301,
POM301, MEMC301,
MEMCW301,
MEMW271, MEMW301,
POMW301

40 or 50 Amp circuit. Refer to local electrical codes
for de-rating requirements.

Advertising
This manual is related to the following products: