Installation, Before you begin, Tools and parts needed – Thermador MEMC301 User Manual

Page 5: Parts included, 27” appliances, General information, Power requirements, Dimensions for 27” wall-mounted units

Advertising
background image

English 3

Installation

Before you Begin

Tools and Parts Needed

Phillips head screwdriver

Measuring tape

Drill with bit (1/8")

Parts Included

Phillips head screws (6)

27” Appliances

General Information

Power Requirements

The outlet must be properly grounded in accordance with all applicable codes.

Dimensions for 27” Wall-Mounted Units

Single Oven 27”
It is good practice, when oven is
installed at the end of a cabinet run,
adjacent to a perpendicular wall or
cabinet door, to allow at least 1/4”
space between the side of the oven
and the wall/door.
For oven support, install 2x4’s
extending front to back flush with the
bottom and the side of the opening.
The supporting base must be well
secured to the floor/cabinet and level.
Note: The conduit box must be
installed either above or below the
unit. If the conduit box is installed
below the unit, a 2” diameter hole or
space is required between the back
wall and the right rear of the 2x4
supports.
The cabinet base must be flat and
capable of supporting a weight of at
least 210 lbs (95 kg).

Advertising
This manual is related to the following products: