Toshiba SR-C8002 - Manual (Page 24)

19/24 SR-C8002 Rev.1.0
8.CD Audio (Test condition: Ordinary temperature)
8.1. Analog Out --- in case of the attenuator is set at 0 dB by the command ---
(1) Output Level 0.8 V (rms)+/-1 dB
(2) Type Unbalanced
(3) Load Impedance 47 kOHM min
(4) Frequency Response 20 Hz to 20 kHz+/-3.0 dB. (at 47 kOHM Load)
(5) Distortion 0.04 % Max. (at 1 kHz w/20 kHz LPF)
(6) Signal to Noise Ratio 80dB Typ (IEC179 A-Weighted)
8.2. Audio Modes
(1) 16 Modes including 'Stereo', 'Lch Mono', 'Rch Mono' and 'Mute' are selectable by command.
Default mode is 'Stereo'.
(2) 16 Steps of attenuation level for the Audio Output is selectable by command.
Default level is 0 dB.
9. Device Configuration Jumper
9.1. Master Mode Setting
Short-circuit the PIN 47 and PIN 48 of I/O connectors.
9.2.Slave Mode Setting
Open the PIN 47 of I/O connectors.
(Optional)
9.1. Master Mode Setting
Open the PIN 47 of I/O connectors.
9.2. Slave Mode Setting
Short-circuit the PIN 47 and PIN 48 of I/O connectors.