Specifications, Limited warranty, Minimum recommended cable sizing – Tripp Lite APSX6048VR User Manual

Page 11

Advertising
background image

Inverter/Charger DC Volt: 48

Wire Gauge

Watts

4

2

0

00

2000

23 ft (7.0 m)

36 ft (11.0 m)

50 ft (15.2 m)

75 ft (22.9 m)

3000

15 ft (4.6 m)

24 ft (7.3 m)

40 ft (12.2 m)

50 ft (15.2 m)

4000

11 ft (3.4 m)

18 ft (5.5 m)

30 ft (9.1 m)

37 ft (11.3 m)

5000

9 ft (2.7 m)

14 ft (4.3 m)

24 ft (7.3 m)

30 ft (9.1 m)

6000

7 ft (2.1 m)

12 ft (3.7 m)

20 ft (6.1 m)

25 ft (7.6 m)

11

Specifications

Note on Labeling

Two symbols are used on the APS labels.

V~

: AC Voltage : DC Voltage

Minimum Recommended Cable Sizing

Use in conjunction with DC wiring connection instructions in the Battery Connection section.

† NOTE: Acceptable power is directly related to cable length (i.e. - the shorter the cable, the better the performance). Cable length
is the sum of the positive cable length and the negative cable length.

MODEL NUMBER:

APSX6048VR

AC Input Connection:

Hardwire

INVERTER

The Inverter/Charger includes a Battery Charge Conserver (Load Sense) Control which saves
battery power by allowing users to set the minimum load level at which the unit’s inverter
turns on. Users can significantly reduce the No Load DC Input Current to a very low amp
level with the use of this control.

Output Volts:

208/230* VAC, ± 5%

Output Frequency (Nominal):

50*/60 Hz, ± 0.5%

Efficiency:

85% to 94%, depending on load and temperature

Continuous Power (@ 20°C):

6000 W

OverPower™ Peak Surge Power:**

9000 W

DoubleBoost™ Peak Surge Power:***

12000 W

DC Input Volts (Nominal):

48 VDC

DC Input Voltage Range:

42-60 VDC

Minimum DC Fuse Rating:

250 A

DC Input Current @ Nominal V DC

Full Load:

138 A

BATTERY CHARGER

Input Volts (Nominal):

208/230* VAC

Charging Capacity DC:

23*/90 A

Acceptance Volts VDC:

57.6*/56.4 V

Selectable (Wet*/Gel)

Float Volts VDC (Wet/Gel):

54*/54.4 V

Charger Only Input Current AC (Maximum):

25 A

LINE VAC OPERATION

Minimum Input Volts (Transfer to Battery):

165*/175VAC (208V) or 170*/180VAC (230V)

Maximum Input Volts (Transfer to Battery):

235*/245VAC (208V) or 260*/270VAC (230V)

Input Frequency (Nominal):

50*/60 Hz, ±10%

Total Input AC Current
(Continuous, Charger at Maximum):

30 A

Maximum Bypass AC
Current (Continuous):

30 A

* Factory setting. ** The Tripp Lite APSX6048VR Inverter/Charger delivers up to 150% of its nameplate-rated wattage for up to 60 seconds under
ideal battery and temperature conditions. For best results, utilize OverPower for as short a duration as possible, ensure that battery bank and
cabling are able to provide full nominal DC voltage under load, and allow the inverter/charger to cool completely before and after OverPower

utilization. *** DoubleBoost duration (up to 10 seconds). Actual duration depends on battery age, battery charge level and ambient temperature.

Regulatory Compliance Identification Numbers
For the purpose of regulatory compliance certifications and identification, your Tripp Lite product has been assigned a unique series number. The series number can be found on the product nameplate label,
along with all required approval markings and information. When requesting compliance information for this product, always refer to the series number. The series number should not be confused with the marking
name or model number of the product.

Limited Warranty

Tripp Lite warrants its Inverter/Chargers to be free from defects in materials and workmanship for a period of one year (except for outside of U.S.A., Canada and Mexico—120 days) from the date of retail purchase
by end user.

Tripp Lite’s obligation under this warranty is limited to repairing or replacing (at its sole option) any such defective products. To obtain service under this warranty you must obtain a Returned Material Authorization
(RMA) number from Tripp Lite or an authorized Tripp Lite service center. Products must be returned to Tripp Lite or an authorized Tripp Lite service center with transportation charges prepaid and must be
accompanied by a brief description of the problem encountered and proof of date and place of purchase. This warranty does not apply to equipment which has been damaged by accident, negligence or
misapplication or has been altered or modified in any way, including opening of the unit’s casing for any reason. This warranty applies only to the original purchaser who must have properly registered the product
within 10 days of retail purchase.

EXCEPT AS PROVIDED HEREIN, TRIPP LITE MAKES NO WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
Some states do not permit limitation or exclusion of implied warranties; therefore, the aforesaid limitation(s) or exclusion(s) may not apply to the purchaser.

EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL TRIPP LITE BE LIABLE FOR DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OF THIS
PRODUCT, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. Specifically, Tripp Lite is not liable for any costs, such as lost profits or revenue, loss of equipment, loss of use of equipment, loss of
software, loss of data, costs of substitutes, claims by third parties, or otherwise.

Tripp Lite has a policy of continuous improvement. Specifications are subject to change without notice.

Advertising