Topcom CLIPPHONE 40 - Manual (Page 17)

3 OPERATION TELEPHONE
3.1 Making a phone call
• Press the Line button. You will hear the dial tone.
The ‘In Use’ indicator (LED) starts to burn.
• Dial the desired telephone number.
• Press the Line button again, after the conversation, to
end the communication.
It is also possible to dial the telephone number first and
then press the Line button. This gives you the opportunity
to erase wrongly entered digits by pressing the Erase button.
3.2 Setting the date and time
• Press the Erase button 3 times until ‘SET’ is shown on
the display.
• Press the Up button.
• The hour indication on the display starts to blink.
• Enter the hour by means of the Up and Down buttons.
• Confirm the setting by pressing the Erase button
• The minute indication starts to blink.
• Repeat these steps to set the minutes, the month and
the day.
After having set the month, the unit will go to the next
setting : Setting the area code.
3.3 Setting the area code
Note : When you have to dial your own area code when making a
phone call to another number in your area, you should not add the
area code.
• Select the first digit of the area code using the Up and
Down buttons.
• Confirm this digit by pressing the Erase button.
• Repeat the same steps to set the other two digits.
• When the correct digits have been selected, press the
Erase button to confirm.
3.4 Flash (R)
Press the Flash button to activate certain services as ‘Call
Waiting’ (if this service is provided by your telephone com-
pany); or to transfer phone calls when you are using a
telephone exchange (PABX).
Clipphone 40
17