Topcom CLIPPHONE 40 - Manual (Page 19)

4 OPERATION CALLER-ID
4.1 Checking and receiving phone calls
The Clipphone 40 receives a call and shows the inform a t i o n
sent by the local telephone pro v i d e r. This information consists
of the caller’s telephone number, the date and the time
(consult your telephone company for the activation).
The phone can save 99 calls which can be reviewed later. It
never saves the same call twice. When the memory is full, the
old calls will be replaced by the new ones in the memory.
4.2 Message indications
The following messages show the status of the phone :
NEW
The unit has received new messages in the
memory.
--P-- The caller has a private number and therefore the
information is not visible on the display.
--O-- The clip information was interrupted during
transmission of the data.
REP The caller has called more than once.
The battery is almost empty.
You received a message in your mailbox.
4.3 Checking and erasing calls
As soon as the phone receives new phone calls, the ‘NEW’
symbol starts to blink on the display until all messages have
been checked. The number of messages that are being
kept, remain visible on the display.
4.3.1 Checking telephone calls
• Press the Up button to go to the next call
• Press the Down button to look at the previous call.
4.3.2 Erasing one call
• Press the Up button to go to the desired call.
• Press the Erase button twice briefly to erase the call.
4.3.3 Erasing all calls
• Press the Up button so that a call from the Call list is
shown on the display.
• Press and hold the Erase button for 3 seconds.
• The call list is completely erased.
Clipphone 40
19