First thing to do, Basic operation – Teac D-01 User Manual

Page 11

Advertising
background image

11

First Thing To Do

Before anything else, you must select a channel for this
unit when you use it for the first time or when you have
reset it back to factory settings.

Press the POWER button to turn the unit on.

1

When the unit is on, the ring surrounding the button lights
up.

“CH_SEL>” appears on the left side of the display.
On the right side, “L R” and channel icons alternately
appear.

Press the OUTPUT button (+/–) to select a channel.

2

Repeatedly press the button until the channel you want to
select appears on the display.

Press the INPUT button to confirm the entry.

3

If you want to change the channel setting, refer to “Channel
Select” in “Changing the Settings” section (page 13).

Basic Operation

Press the POWER button to turn the unit on.

1

When the unit is on, the ring surrounding the button lights
up.

<

Also be sure the connected components are turned on.

<

When the WORD button is set to “IN” or “Rb IN”, “WRD
UNLOCK!” or “No Word!” may appear, as it takes several
seconds for the unit to lock the word clock input from the
WORD SYNC IN terminal. The message will disappear when
the unit locks to the word clock.

Make digital filter, etc. settings.

See pages 12 and 13 for details.

Select the input using the INPUT button.

3

2

After selecting the input, play back the source unit.

<

Always turn off the unit after use.

<

If the XLR1 or XLR2 is selected and the XLR DUAL signal is
input, the indicator turns from blue to violet

Advertising