Troy-Bilt TB425CS EU - Manual (Page 17)

17
3. Wash the filter in detergent and water (Fig. 57). Rinse
the filter thoroughly and allow it to dry.
4. Apply enough clean SAE 30 motor oil to lightly coat
the filter (Fig. 58).
Fig. 57
5. Squeeze the filter to spread and remove excess oil
(Fig. 59).
Fig. 59
Fig. 58
MAINTENANCE AND REPAIR INSTRUCTIONS
AIR FILTER MAINTENANCE
Cleaning the Air Filter
Clean and re-oil the air filter every 10 hours of operation.
It is an important item to maintain. Failure to maintain
your air filter properly can result in poor performance or
can cause permanent damage to your engine.
1. Open the air filter cover. Push the tab on the right
side of the cover inward. Then pull the air filter cover
out and to the left (Fig. 56).
NOTE: It may be necessary to remove the fuel cap to
completely remove the air filter cover.
2. Remove the air filter (Fig. 56).
Air Filter
Air Filter Cover
Tab
Fig. 56
To avoid serious
personal injury,
always turn the unit off and allow it to cool
before you clean or service it.
WARNING:
Fig. 60
Back Plate Slot
Slots
6. Replace the filter (Fig. 60).
NOTE: If the unit is operated without the air filter, you
will VOID the warranty.
Back Plate
7. Reinstall the air filter cover. Position the hooks on
the left side of the air filter cover into the slots at the
left side of the back plate (Fig. 60).
NOTE: It may be necessary to remove the fuel cap to
reinstall the air filter cover.
8. Swing the cover to the right until the tab on the air
filter cover snaps into place in the slot on the back
plate (Fig. 60).
9. Replace the fuel cap if it was removed.
CARBURETOR ADJUSTMENT
The idle speed of the engine is adjustable. An idle
adjustment screw is reached though a hole in the top of
the engine cover (Fig. 61).
NOTE: Careless adjustments can seriously damage your
unit. An authorized service dealer should make
carburetor adjustments.
Check Fuel
Old fuel is usually the reason for improper unit
performance. Drain and refill the tank with fresh fuel prior
to making any adjustments. Refer to Oil and Fuel
Information.