Toshiba Strata CIX IP5000-UG-VC - Manual (Page 177)

Administrator Programming
IP5131-SDL Settings
Strata CIX IP5000-series Telephone UG 07/09
159
Repeat Delay Timer and Repeat Rate Timer
Important! The following steps apply to the above two items.
 From the IP Configurations menu, select Key Repeat
> Repeat Delay Timer or Repeat Rate Timer. The
appropriate screen displays (shown right).
 To Change Information on this screen
1. Enter the New Repeat Delay Timer to change the
setting.
Note Use the dial pad 1~5 and
Vol
t to backspace.
For Repeat Delay Timer: 1 (short) to 5 (long).
For Repeat Rate Timer: 1 (fast) to 5 (slow)
2. Press the Set soft key to accept the change
...or press the Cancel soft key to cancel the change and go to the Key Repeat
Setting screen.
Notes
• Pressing the Set soft key can give you an Error screen if you incorrectly entered the
timer value (outside of acceptable range).
• Press the Ok soft key on the Error Screen to correct the entry. Five seconds after
the Error Screen displays, the screen automatically goes back to the Repeat Delay
Timer or Repeat Rate Time screen and the number that resulted in an error will
display.
Handset Tx Volume
1
Backspace = Vol-Down
[Set] [Cancel]
Config
:Current
:New (1: Short.- 5:Long)