Teac X-03 - Manual (Page 10)

10
Front panel features
The equipment draws nominal non-operating power from
the AC outlet with its POWER switch in the OFF position.
A B C D E G H I J F
POWER
Use this to turn the unit on and off. When the unit is on, the
ring surrounding the button lights up.
CLOCK MODE
Use this to select an external word sync source connected to
the WORD SYNC connector on the rear panel.
Remote control sensor
Receives signals from the remote control unit. Point the
remote control unit at this sensor when operating the remote
control unit.
Display
Disc tray
OPEN/CLOSE
Use this to open and close the disc tray.
STOP
Use this to stop playback. When playback is stopped, the ring
surrounding the button lights up.
Also use this to change the i.LINK output setting.
PLAY
Use this to start playback. When a disc is being played back,
the ring surrounding the button lights up.
PAUSE
Use this to pause playback. When playback is temporarily
paused, the ring surrounding this button lights up.
SKIP (.//)
Use these for skip operations. Pressing and holding these
buttons for more than a second changes the scanning speed.
J
I
H
G
F
E
D
C
B
A
Disc type indicator
Shows the type of disc currently loaded.
TRACK indicator
Indicates that the track number is being shown.
TOTAL indicator
Indicates that the total time is being shown.
REMAIN indicator
Indicates that the remaining time is being shown.
DOWN MIX indicator
Lights to show that a multi-channel source has been
downmixed to two channels.
5.1CH indicator
Lights when the Analog Out setting is set to “Multi ch”.
Channel indicators
Light to show which surround channels are currently in use.
Message area
Alphanumeric display to show times, status messages, etc.
REPEAT indicator
Lights when repeat play is selected.
Pause indicator
Lights when playback is paused.
Playback indicator
Lights when playing back.
k
j
i
h
g
f
e
d
c
b
a
a b c
g h j i k
d e f
Display