Tascam US-144MKII - Manual (Page 11)

TASCAM US-144MKII
11
Rear panel
u USB connector Use the provided USB
cable to connect this to the host computer’s
USB 2.0 port.
NOTE
If the US-144MKII is operating •
with a USB 1.1 (USB 2.0 Full Speed)
connection, the sample rate choices
will be limited to 44.1 kHz and 48 kHz.
If the unit is operating with a USB 1.1 •
(USB 2.0 Full Speed) connection, the
transfer of audio data with the computer
by USB is limited to either 2 channels of
input or 2 channels of output.
The US-144MKII obtains power from the •
host computer via the USB cable. In rare
cases, a computer’s USB port may not be
able to supply enough power to operate
the US-144MKII. If this occurs, consider
purchasing a USB 2.0 hub that comes
with its own external power supply.
i DIGITAL IN (COAXIAL) connector
Coaxial digital input jack that conforms
to the IEC60958 (S/PDIF) standard for
consumer use.
o DIGITAL OUT connector Coaxial
digital output jack that conforms to the
IEC60958 (S/PDIF) standard for consumer
use and the IEC60958 (AES/EBU) standard
for professional use.
NOTE
Simultaneous input and output at
24-bit/96-kHz is possible with this unit’s
DIGITAL IN and OUT jacks.
p MIDI OUT connector Transmits MIDI
messages.
a MIDI IN connector Receives MIDI
messages.
s LINE OUT L/R jacks (RCA connector,
unbalanced) These are analog stereo output
jacks.
2 – Parts of the US-144MKII