Topcom Butler 6040 - Manual (Page 21)

Topcom Butler 6040 21
Topcom Butler 6040
ENGLIS
H
8.2 Handset priority
Normally, if you have more than one handset registered to your base, they all ring at the
same time. However, you can set one of them to ring before the others, so that calls can
always be answered at one handset first.
•
From the standby screen, press MENU then scroll to Base settings and press OK.
• Scroll to Handset Priority and press OK. Display highlights All Handsets. Press OK
to select All Handsets
• to make all handsets ring together.
Or
•
Scroll to Select Handset and press OK. Scroll or to the handset you want to ring
first. Press OK.
• Scroll or to select the number of rings at the handset before the other handsets
start ringing. Press OK to confirm.
8.3 Line settings
8.3.1 Dial mode
There are two types of dialling mode:
1) DTMF/tone dialling (the most common)
2) Pulse dialling (for older installations)
• Press MENU then scroll to Base Settings and press OK. Scroll to Dial Mode and press
OK.
• Press or to highlight Pulse or Tone and press OK to confirm.
8.3.2 Flash time
•
Press MENU then scroll to Base Settings and press OK. Scroll to Recall Mode and
press OK.
• Press or to highlight Recall 1 for short flash time (100ms) or Recall 2 for long flash
time (250ms) and press OK to confirm.
8.3.3 Ring pulse alerting signal (RPAS) on/off
Then you have callerID, the network send a short ring signal as an alerting signal before
sending the caller number. To avoid the telephone to ring during this first ring signal you have
to set the RPAS inhibitation to off.
• Select Menu then scroll to Base settings and press OK
• Scroll to RPAS inhibition and press OK
• Select Off to disable the phone to ring during the first ring burst, or On to enable the
ringing and press OK
• Press and hold Back to return to standby