10 additional handsets and bases – Topcom Butler 6040 User Manual
Page 30
30
Topcom Butler 6040
Topcom Butler 6040
9.9.1 Delete template
•
From the standby screen, press SMS to open the SMS menu.
•
Scroll down to Templates and press OK. Scroll to the template you want and press OK.
Scroll to Delete Template. Press OK.
10 Additional handsets and bases
You can subscribe up to 5 handsets on a Butler 5500 base. Each handset can register to 4
base stations and the user can select which base he wants to use.
10.1 Adding a new handset
Only needed when you have deregistered a handset or when you bought a new one !!
First put the base into registration mode:
•
Press and hold the paging button on the base until you hear two beeps.
•
The
LED will start to blink on the base for 90 seconds. During that time the base is
ready to register a handset.
On the handset:
•
Select Menu to open the menu.
•
Select Registration with the navigator and press OK.
•
Select Register Handset with the navigator and press OK.
•
Select the number of the base to be associated with the handset (1 to 4). Confirm by
pressing OK.
•
Enter the system PIN (0000 by default) and confirm with OK. A series of numbers
appears on the screen, representing the base ID. Confirm with 0K. Your handset is
registered.
10.2 Removing a handset
This procedure needs to be carried out on a different handset from the one you want to
uninstall.
•
Select Menu by pressing the left menu key.
•
Select Registration with the navigator and press OK.
•
Select De-register with the navigator and press OK. Enter the system PIN (0000 by
default) and press OK.
•
Select the handset to uninstall with the navigator and press OK.
10.3 Select a base
You can switch your Butler 6040 handset between bases. You can also set it to automatically
base select with the strongest signal. The handset must first be registered with each base
individually.
•
Press MENU then scroll to Registration and press OK.
•
Scroll to Select Base then press OK. The current base being used is highlighted.
•
Select the base you want or select Automatic to connect to the base with the strongest
signal. Press OK.