Tripp Lite BP72V122U - Manual (Page 3)

3
SUGGESTED
INSTALLATION FOR 2-POST
RACK ENCLOSURES
1) On both sides of your Battery Pack, connect
one mounting ear (A) with four screws and flat
washers (B) to the Battery Pack's middle four
mounting holes. The mounting surface of the
ear should face the front of the Battery Pack.
2) Have one or more assistants lift the Battery
Pack and hold it in position until this step is
complete. Insert the Battery Pack into its
intended rack space, until the mounting sur-
faces of its ears (C) meet the outside of the
rack's rails (D). Connect the mounting ears to
the rails with two screws and flat washers
(user supplied, E) on each side.
SUGGESTED WALLMOUNT
INSTALLATION
1) On both sides of your Battery Pack, connect
one mounting ear (A) to the Battery Pack's
four front mounting holes and
another mounting ear (B) to the four rear
mounting holes, using four screws and flat
washers (C) with each ear. The mounting
surfaces of the ears should face up and out,
and the bottom of the ears should be flush
with the bottom of the Battery Pack.
2) Have one or more assistants lift the Battery
Pack and hold it in position until this step is
complete. Move the Battery Pack to its intended wall space
and hold it so that the mounting surfaces of its ears (D) are
pressed to the wall. Attach the ears to the wall with two
screws and flat washers (user supplied, E) each.
OR
D
E
E
200005167 Rackmount Battery Pack Manual (Revised).p65 8/15/00, 12:50 PM 3