TANDBERG D1392602 - Manual (Page 17)

TANDBERG Video Portal Data port Command Interface User Guide
or
SIP Interface Transport Default: <TCP/UDP/TLS>
---
sub-commands:
• Mode: Specifies whether the system uses a default SIP proxy.
• Address: Specifies the IPv4 address or FQDN of the SIP proxy.
• Type: Specifies the type of the SIP proxy.
• Transport Default: Determines which transport type will be used for SIP calls to and
from the traversal server.
Example of SIP feedback:
*c xConfiguration SIP Mode: On
*c xConfiguration SIP Interface Server Address: "127.0.0.1"
*c xConfiguration SIP Interface Server Type: Auto
*c xConfiguration SIP Interface Transport Default: UDP
SNMP Configures the SNMP.
Note! For more information about SNMP please read the TANDBERG SNMP application note.
SNMP Mode < On/Off/ReadOnly/TrapsOnly >
or
SNMP CommunityName: <S: 0, 16>
or
SNMP SystemContact: <S: 0, 70>
or
SNMP SystemLocation: <S: 0, 70>
or
SNMP HostIPAddr [1..3]: <IPAddr>
---
parameters:
• Mode: < On/Off/ReadOnly/TrapsOnly >
• Community Name: Text string of maximum 16 characters.
• System Contact: Text string of maximum 70 characters
• System Location: Text string of maximum 70 characters
• Host IP Addr: The IP addresses of max 3 SNMP trap hosts
sub-commands:
• Mode enables or sets the mode of SNMP support
• Community Name is used to authenticate SNMP requests. SNMP requests must have
this ‘password’ in order to receive a response from the SNMP agent in the Video Portal.
• System Contact, Used to identify the system contact via SNMP tools such as
HPOpenView or TANDBERG Management Suite
• System Location Used to identify system location via SNMP tools such as
HPOpenView or TANDBERG Management Suite
• Host IP Addr identifies the IP-address of the SNMP manager. Up to three different
SNMP Trap Hosts can be defined. Your LAN administrator should provide the correct
values for these fields
Example of SNMP feedback:
*c xConfiguration SNMP Mode: On
*c xConfiguration SNMP CommunityName: "public"
D1392602 17