Toshiba VM4050 - Manual (Page 28)

Answering Calls
To answer an incoming call:
1. Make sure your phone is on. (If your phone is off, incoming calls
go to voicemail.)
2. When your phone rings or vibrates, press to answer the
incoming call. (Depending on your phone’s settings, you may
also answer incoming calls by opening the phone or by pressing
any digit key.)
Your PCS Phone notifies you of incoming calls in the following ways:
ᮣ
The phone rings or vibrates.
ᮣ
The LED flashes green.
ᮣ The backlight illuminates.
ᮣ
The screen displays an incoming call message.
ᮣ
If available, the phone number of the caller is displayed.
ᮣ
If the phone number is in your internal Phone Book, the Phone
Book entry’s name is displayed.
Tip: To mute the ringer or stop the vibrating, press or press any of three
keys on the side of your phone.
Tip: To answer the call using the speakerphone mode, press .
Answering a Roam Call With Call Guard Enabled
To answer a call when you are roaming and Call Guard is enabled:
Ⅵ Press and press to answer the call. (See “Call Guard”
on page 61 for additional information.)
Note: If your phone is off, incoming calls go to voicemail.
Ending a Call
To disconnect a call when you are finished:
Ⅵ Close the phone or press .
Note: When you use the phone with an earphone-microphone or TTY device, you
can continue a call even if the phone is closed.
END
1 TALK
END
TALK
Section 2: Understanding Your PCS Phone
2A: Your PCS Phone – The Basics 17