Troy-Bilt 42012 - Manual (Page 12)

12
Section 2: Assembly
Fig. 2-9
AF
AB
Yellow
Yellow &
Red Wires
AL
AO
AN
AM
AK
Black
Black
Blue
Red
Fig. 2-10
I. Attach Wheel Drive Control Rod
1. Remove the plastic cable tie that
secures the wheel drive control rod
(AE, Fig. 2-8) and the gear shift
control rod (AF) to the left handlebar.
2. Hook the spring (AG, Fig. 2-8) at the
lower end of the wheel drive control
rod (AE) into the hole in the wheel
drive control arm (AH). If necessary,
raise the wheel drive control arm (AH)
while attaching the spring.
3. The wheel drive control rod has been
pre-adjusted at the factory. When the
engine is started, as described in the
“Operation” section, you will be given
a functional check to make sure the
wheel drive control rod is properly
adjusted.
J. Install Gear Shift Control Rod
1. Place the gear shift select lever (T, Fig.
2-6) in the No. 5 position.
2. Gently push the transmission shift arm
(AB, Fig. 2-9) fully downward.
3. Align the holes in the transmission
shift arm (AB) and the lower end of the
gear shift control rod (AF). If the
holes do not align, follow the “Gear
Shift Rod Adjustment” procedure in
the “Maintenance” section of this
manual.
4. Attach the gear shift control rod (AF)
to the transmission shift arm (AB) with
the two 1/4-20 x 3/4 hex head screws
and 1/4-20 locknuts supplied (see
Fig. 2-9).