Troy-Bilt 42012 User Manual

Page 27

Advertising
background image

27

Section 5: Maintenance

POSSIBLE PROBLEM

Ignition key in STOP position

Choke knob in incorrect position

Engine throttle lever in incorrect starting

position

Engine not primed enough (when cold)

Engine primed too much (when cold)

Spark plug wire disconnected

Fouled or faulty spark plug

Gasoline tank empty

Fuel shutoff valve is closed

Carb / fuel line “varnished” from old gas

Incorrect choke knob setting

Engine throttle lever in incorrect position

Fuel shutoff valve closed

Engine not primed enough

Stale gasoline in tank

Fouled or faulty spark plug

Faulty or fouled spark plug

Incorrect choke setting

Dirty air screen

Low engine oil level

Dirty cooling fins

Loose spark plug

Tension too low on spring at lower

end of auger drive control rod

Broken auger shear bolts

Loose or broken spring

SOLUTION

Turn key to RUN “ ” position

Move choke knob to FULL CHOKE position

Move throttle lever to correct

starting position

Push primer button several more times

Rotate choke knob to OFF position, move

throttle lever to idle position, attempt

to start engine, then proceed with normal

starting procedure. DO NOT re-prime!

Connect spark plug wire to spark plug

Remove, clean, inspect, re-gap or replace

spark plug

Fill gasoline tank

Open fuel shutoff valve

Contact dealer

Rotate choke knob to correct setting

Rotate throttle lever to correct

starting position

Open fuel shutoff valve

Push primer button several more times

Drain gasoline from tank, refill tank with

fresh gasoline

Remove, clean, inspect, re-gap or replace

spark plug

Remove, clean, inspect, re-gap or replace

spark plug

After the engine starts, gradually rotate the

choke knob to the NO CHOKE position

Remove all debris from air screen

Check oil, add as necessary

Clean cooling fins

Disconnect spark plug wire, re-tighten plug

Increase tension on spring

Replace auger shear bolts

Replace spring

(continued)

TROUBLE

Engine won’t start

Engine difficult to start

Engine idles rough

Engine overheats

Auger drive lever does not actuate auger

Troubleshooting

Advertising
This manual is related to the following products: