Taylor AC-1200-BL - Manual (Page 6)

6
USING YOUR CHOPPER & BLENDER PREP SYSTEM
BEFORE FIRST USE
•
Make sure the voltage in your outlet is the same as the voltage indicated on
the appliance. This product is for 120 –Volt AC electrical outlet only.
• The chopper bowl is equipped with a safety locking system to increase secu-
rity during operation. The chopper function will not work if the chopper
bowl, blades and cover are not properly locked in place.
• Remove any bags, labels or stickers from the appliance.
• Clean the unit with a damp soft cloth.
• Wash all of the removable parts – chopper bowl, blade and cover, blender con-
tainer, cover and measuring cup, using a sponge, warm water and mild dish
detergent. Rinse and dry carefully.
• NOTE: do not immerse the base unit in water when cleaning
HOW TO USE YOUR CHOPPER
• Place the unit on a flat, sturdy surface with adequate clearance (i.e., do not
place under wall cabinets or on carpeting or other soft surfaces). This appli-
ance is not for use in convection or conventional ovens, microwaves, or on
stovetop.
• Make sure the appliance is switched off and unplugged.
• Wash and dry all components thoroughly as stated above.
• Assemble with chopper components. Always be sure that the appliance is
properly assembled before using. Chopper blades are extremely sharp; never
touch the cutting edge of blades.
• Clean and wash the food to be used.
• Add food ingredients to the chopping bowl, distributing them evenly with a
spatula (not included). When chopping larger foods, pre-cut them into pieces
of an even size, approximately ½ inch to ¾ inch pieces.
• Place the cover onto the chopper bowl. NEVER OPERATE THE
CHOPPER UNLESS THE COVER AND BOWL ARE COR-
RECTLY LOCKED IN.
• Plug the appliance into the power outlet.
• Start the chopper by pushing the 2 speed button continuously. The chopper
operates with pulse control – press the button once and the chopper will op-
erate for 45 seconds then stop automatically. Press the button again to operate
for an additional 45 seconds.
• Reverse the above procedure to remove the chopper cover, blade and bowl.