Thermador DW44ZSB - Manual (Page 17)

EN- GLISH
Thermador Dishwasher Model DW44Z www.thermador.com
Accommodating Extra Tall Items
If you have extra tall items that cannot fit in the bot-
tom rack without interfering with the upper spray arm
or without hitting the top rack (max. height 22"), you
can remove the upper rack. A special accessory, the
Extra Tall Item Sprinkler, lets you run the dishwasher
with top rack removed. See Figures 27 and 28.
Installing ‘Extra Tall Item Sprinkler’
1. With top rack empty, remove it from the
dishwasher by pulling the rack toward you to the
point where you can lift it up and out, disengaging
the wheels from the side rails.
2. Place the “Extra Tall Item Sprinkler” over the top
rack spray outlet at the back of the dishwasher
tub and turn it clockwise to lock the sprinkler head
in place. See Figure 26.
3. Place the extra tall items in the bottom rack for
washing, as shown in Figure 25. To remove the
Extra Tall Item Sprinkler, turn it counterclockwise
and pull it out. Then replace the top rack.
Cycle Completion Signal
At the end of a wash cycle, the beeper will sound off
two times, and again every 15 minutes until the dish-
washer is turned off.
To Enable or Disable the Cycle Completion Signal
1. Open the door, hold down the “Light Wash” button
and simultaneously turn the Dishwasher on. The
“Light Wash” light will blink (program mode).
2. While the light is still blinking, push the “Light Wash”
button.
•
If the machine beeps, then the Cycle
Completion Signal has been enabled.
• When you push the button again and it does
not beep, it means that the Cycle Completion
Signal has been disabled.
3. Turn the Dishwasher off to take it out of program
mode.
NOTE: Be sure to remove the
Extra Tall Item Sprinkler be-
fore you reinstall the top rack,
otherwise the door could be-
come damaged and not close
properly.
Page 15
Figure 25
Figure 26