Toshiba SD-R5112 - Manual (Page 30)

23/29 SD-R5112 Rev.1.0
8.CD Audio (Test condition: Ordinary temperature)
8.1. Analog Out --- in case of the attenuator is set at 0 dB by the command ---
(1) Output Level 0.79 V (rms) Typ.
(2) Type Unbalanced
(3) Load Impedance 47 kOHM min.
(4) Frequency Response 20 Hz to 20 kHz +/-3 dB
(5) Distortion -73 dB (at 1 kHz JIS A-Weighted)
(6) Signal to Noise Ratio 80 dB Typ. (IEC 179 A-weighted)
8.2. Digital Out
(1) Output Level 0.50 V (p-p)
(2) Type Unbalanced
(3) Load Impedance 75 OHM
8.3.Connector
4P connector and 2P connector.
Digital out
Digital Audio
GND R L GND
Analog Audio
GND
#2 #1
#4 #3 #2 #1
Figure 14
8.4. Audio Modes
(1) 16 Modes including 'Stereo', 'Lch Mono', 'Rch Mono' and 'Mute' are selectable by command.
Default mode is 'Stereo'. Audio out is automatically muted in the digital data area and seek state.
(2) 16 Steps of attenuation level for the Audio Output is selectable by command.
Default level is 0 dB.
8.5. Headphones Output (Option).....in case of the attenuator set at 0 dB by the command.....
(1) Output Level 0.90 V (rms) Typ.
(2) Level Adjust Controller Continuous Type (Thumb Wheel Knob)
(3) Load Impedances 100 OHM (Nominal)
8.5.1. Connector
3.5 mm dia. Stereo Headphones Jack.