Toshiba SD-R5112 - Manual (Page 33)

26/29 SD-R5112 Rev.1.0
11.Connection
11.1. Power Supply Cable
(1) Housing AMP JAPAN P/N 1-480424-0 or equivalent
(2) Contact AMP JAPAN P/N 170148-2 or equivalent
(3) Cable Length AWG #28
Max. 2 m
11.2. Interface Cable
(1) Connector ATAPI specification
(2) Cable 40 core type
Specific Impedance 100 OHM +/-10 % (without shield)
Length Max. of 0.46 m for total ATAPI bus length
11.3. Audio Cable Unbalanced and shielded
(1) Capacitance Less than 1000 pF
(2) Length Max. 3 m
12.Emergency Eject
Execute following procedure only in the case of emergency (Tray will not eject and disc
can not be removed although pressing Eject Button).
(1) Turn the drive supplying power off.
(2) Insert solid bar (like paper clip) into Emergency Eject hole and push as shown in Fig.21.
Then Tray will be ejected.
(3) After removed the disc, gently push Tray to close.
50 mm
diameter 1.0 to 1.5 mm
Figurer 21 Insert the bar