TDK GENESYS 1500W User Manual
Page 16
83-507-013 Rev. D
8
1.2.9
Cooling and mechanical construction
The Genesys
TM
series is cooled by internal fans. At the installation, care must be taken to allow free
airflow into the power supply via the front panel and out of the power supply via the rear panel. The
Genesys
TM
power supplies have a compact and lightweight package, which allows easy installation
and space saving in the application equipment.
1.3 ACCESSORIES
1.3.1 Included Accessories
The following accessories are delivered with the power supply:
1.3.1.1 Serial Link Cable
Serial link cable for linking power supplies by RS-485 communication.GEN/RJ45.
Cable description: 0.5m Length, shielded, RJ-45 type plugs, eight (8) contacts (P/N 15-507-201)
1.3.1.2 Hardware (delivered with power supply)
•
Strain Relief for AC Cord
•
Output terminal Shield
•
DB25 Programming Plug kit (AMP 749809-9)
•
750W Only - Power Cord
•
1500W Only - No Power Cord is Provided.
•
1500W Only Input Connector plug kit (Phoenix Contact, plug: IMC 1,5/7-ST-3,81, Header: IMC 1, 5/7-G-
3,81))
1.3.2 Optional Communication Cables (See Para. 7.5)
•
RS-232 Cables to connect GEN to Serial Port on PC
GEN to PC (DB9)
GEN 232/9
P/N 15-507-203
GEN to PC (DB25)
GEN 232/25
P/N 15-507-204
•
RS-485 Cable to connect GEN to Serial Port on PC
GEN to PC (DB9)
GEN/485-9
P/N 15-507-202)
1.3.3
AC cables
AC Cables are provided with 750W Model only, according to suffix in Model Number.
For 750W Genesys
TM
power supplies:
Part No.
Market
Description
NC301
(GEN/U)
USA
13A 125V, unshielded, 2m typical length, with IEC320 connector on one end and NEMA-
5-15P connector on the other end.
NC302
(GEN/E)
Europe
10A 250V, unshielded, 2m typical length, with IEC320 connector on one end and INT’L 7
standard VII, dual earthing.
NC303
(GEN/O)
General
10A 250V, unshielded, 2m typical length, with IEC320 connector on one end and unter-
minated stripped wires on the other end. Use the cable only with plug approved by the
national safety standards of the country of usage.
NC305
(GEN/J)
Japan
13A 125V, unshielded, 2m typical length, with IEC320 connector on one end and Japan
type plug on the other end.
NC306
(GEN/GB)
UK
10A 250V unshielded, 2m typical length, with IEC320 connector on one end and UK type
plug on the other end.
For 1500W Genesys
TM
power supplies the recommended AC cable (customer supplied) is:
25A 250V, 3x12AWG, outer diameter: 9-11mm, rated 60°C min., 3m max. length. Add a
non-locking plug approved by the national safety standards of the country of usage.
CAUTION
Observe all torque guidelines within this manual. Over-torquing may damage
Unit or accessories. Such damage is not covered under manufacturers warranty.