TDK GENESYS 1500W - Manual (Page 72)

83-507-013 Rev. D
64
7.11.2 Conditional Registers (continued)
Table 7-8: Fault Condition Register
BIT Fault name Fault symbol Bit Set condition Bit Reset condition
0 (LSB) Spare bit SPARE Fixed to zero Fixed to zero
1 AC Fail AC AC fail has occurred. The AC input returns to normal.
2 Over
temperature OTP OTP shutdown has
occurred. The power supply cools down.
3 Foldback FOLD Foldback shutdown
has occurred The supply output is turned On by front
panel button or OUT 1 command.
4 Over voltage OVP OVP shutdown has
occurred. The supply output is turned ON by front
panel button or OUT 1 command.
5 Shut Off SO Rear panel J1 “Shut
Off” condition has oc-
curred. Rear panel J1 “Shut Off” condition has
been removed.
6 Output Off OFF Front panel OUT but-
ton pressed to Off. The supply output is turned On by front
panel button or OUT 1 command.
7(MSB) Enable ENA Rear panel J1 Enable
terminal (J1-1&J1-14)
opened. Rear panel J1 Enable terminals closed.
Table 7-9: Status Condition Register
BIT Fault name Fault symbol Bit Set condition Bit Reset condition
0 (LSB) Constant
Voltage CV Output is On and the
supply in CV. Output is ON and the supply is not in
CV.
1 Constant
Current CC Output is ON and the
supply in CC. Output is ON and the supply is not in
CC.
2 No Fault NFLT The power supply is
operating normally or
fault reporting is not
enabled.
See “OUT n” com-
mand in Section 7.7.5. One or more faults are active and fault
reporting is enabled (using “FENAxx”).
3 Fault active FLT One or more faults are
enabled and occur. Fault Event Register cleared (FEVE?).
4 Auto-Restart
Enabled AST Supply is in Auto-
Restart mode (from
Front Panel or serial
command). Supply is in Safe-Start mode (from
Front Panel or serial command).
5 Fold
Enabled FDE Fold protection is
enabled (from Front
Panel or serial
command). Fold protection disabled (from Front
Panel or serial command).
6 Spare bit SPARE Fixed to zero. Fixed to zero.
7(MSB) Local Mode LCL Supply in Local mode. Supply in Remote mode or Local-
Lockout mode.
7.11.3 Service Request: Enable and Event Registers
The conditional Registers are continuously monitored. When a change is detected in a register bit
which is enabled, the power supply will generate an SRQ message.
The SRQ message is: “Inn” terminated by CR, where the nn is the power supply address. The SRQ
will be generated either in Local or Remote mode.