Toshiba SG-1801 - Manual (Page 12)

12
Preparation
CHARGING THE BATTERY PACK
It is important to charge the battery for 12-16 hours continuously
without any interruption before you use the handset for the first
time.
1
Remove the battery cover on the
back of the handset by sliding it
down.
2
Plug the battery pack cord into the
connector with the correct polarity.
(black and red wires).
3
Place the battery pack in the battery
compartment.
4
Put the battery cover back by
sliding until it snaps into place.
Make sure not to get the wires of
the battery pack caught in the
cover.
5
Place the handset on the base unit.
Be sure the IN USE/CHARGE LED
lights.
If the IN USE/CHARGE LED does
not light, make sure the AC adaptor
is plugged in securely.
NOTES:
• Use only the supplied battery pack (TRB-1981 power source 800mAh, 3.6VDC)
• The battery pack is not charged properly if the charging contacts are dirty or
tarnished. Clean the contacts occasionally with a dry cloth.
INSTALLATION
Red
Black
IN USE/
CHARGE
LED
Charging contacts
SG-1801.qxd 4/19/1 9:12 AM Page 12