Technicolor - Thomson 210i - Manual (Page 58)

SpeedTouch 210i
54
♦
RX Pkts – Total number of received IP packets received during this
connection session.
♦
RX Rate – Reception rate for ingoing data. The unit is characters per second
(cps).
♦
Up Time – Connection time. The format is HH:MM:SS where HH means
hours, MM means minutes, and SS means seconds.
♦
AOC – The Advice of Charge (AOC) service allows you to view information
concerning charges for a call.
♦
Drop B1 – Click to disconnect the B1 channel.
♦
Drop B2 – Click to disconnect the B2 channel.
LAN Status
♦
IP Address – IP address of the LAN interface.
♦
TX Packets – Total number of transmitted IP packets send since the router
was powered on.
♦
RX Packets – Total number of transmitted IP packets received since the
router was powered on.
WAN Status
♦
Mode – Indicates which broadband access mode is active. Depending upon
the broadband access mode, you may see Static IP, PPTP, or PPPoE.
♦
GW IP Address – Indicates the gateway IP address.
♦
IP Address – The 2nd IP Address of Ethernet or the IP address of WAN
interface that is from PPTP/PPPoE connection.
♦
TX Packets – Total number of transmitted IP packets sent during this
connection session.
♦
TX Rate – Transmission rate for outgoing data. The unit is characters per
second (cps).
♦
RX Packets – Total number of transmitted IP packets received during this
connection session.
♦
RX Rate – Reception rate for ingoing data. The unit is characters per second
(cps).
♦
Up Time – Connection time. The format is HH:MM:SS where HH means hour,
MM means minute, and SS means second.
♦
Drop PPPoE or PPTP – Click to disconnect the PPPoE or PPTP connection.
Time Setup
Click Time Setup to open a page that allows you to make configuration changes to the
time setup.