Media care, Media care -13, Cd/dvds – Toshiba U300 Series PSA50 YXT User Manual

Page 58

Advertising
background image

User’s Manual

4-13

Operating Basics

If you add data to a DVD-R and DVD+R disc that you have already

recorded to, you might not be able to read the added data under some

circumstances. It cannot be read in 16-bit operating systems, such as

Windows 98SE and Windows ME, in Windows NT4 you will need

Service Pack 6 or later to read the data, and in Windows 2000 you will

need Service Pack 2 or later to read it. Some optical media drives

cannot read added data regardless of the operating system.

TOSHIBA Disc Creator does not support recording to DVD-RAM discs.

To record to a DVD-RAM, use Explorer or other similar utility.

When you back up a DVD disc, be sure the source drive supports

recording to DVD-R/-RW or DVD+R/+RW discs. If the source drive

does not support recording to DVD-R/-RW or DVD+R/+RW discs, it

might not be backed up correctly.

When you back up a DVD-R, DVD-RW, DVD+R or DVD+RW, be sure to

use the same type of disc.

You cannot partially delete any data written to a CD-RW, DVD-RW or

DVD+RW disc.

Data Verification

To verify that data is written or rewritten correctly, follow the steps below

before you write or rewrite a Data CD/DVD.
1. Display the setting dialog box by one of the following two steps:

Click the setting button (

) for writing on the main toolbar in the

Data Disc mode.

In the Settings menu, select Settings for Each Mode, then Data

Disc.

2. Mark the Verify Written Data check box.
3. Select File Open or Full Compare mode.
4. Click the OK button.

Media care

This section provides tips on protecting data stored on your CD/DVDs.
Handle your media with care. The following simple precautions will

increase the lifetime of your media and protect the data stored on them:

CD/DVDs

1. Store your CD/DVDs in the container they came in to protect them and

keep them clean.

2. Do not bend the CD/DVD.
3. Do not write on, apply a sticker to, or otherwise mar the surface of the

CD/DVD that contains data.

4. Hold the CD/DVD by its outside edge or the edge on the centre hole.

Fingerprints on the surface can prevent the drive from properly reading

data.

Advertising
This manual is related to the following products: