TANDBERG D13187-03 - Manual (Page 15)

TANDBERG Gateway
15
Installation
Gateway Configuration
The gateway requires some basic configurations before it can be used. It will be necessary to find the IP-address
and program the ISDN-PRI Line numbers.
To do this configuration, follow the instructions below:
1. Connect the RS232 cable between the gateway and a PC and then switch on the gateway.
2. Start a terminal program on the PC and configure it to: 9600, 8, 1, None.
3a. To assign a static IP-address, type ‘ipassign static’ and ‘ipaddress 1 static <IP-address>’.
3b. To assign an IP Subnetmask, type ‘ipaddress 1 subnetmask <subnetmask>’.
3c. To assign an IP Gateway address, type ‘ipaddress 1 gateway <gateway IP-address>’.
4. Restart the gateway.
5. Start a WEB browser and enter the IP-address of the gateway. Default password: ‘TANDBERG’.
6. To configure the gateway for ISDN dial in, enter PRI numbers and dial in number(s). For details, see
the ‘PRI Configuration’ and the ‘ISDN Dial in Configuration’ section.
7. To configure the gateway for IP dial in, register the gateway to a gatekeeper and enter H.323
services. For details, see the ‘H.323 Services’ and ‘H.323 Configuration’ sections.
TIP DHCP ASSIGNED IP- ADDRESSES ARE SUPPORTED BY THE TANDBERG G ATEWAY ( FACTORY DEFAULT ).