Topcom 2000 - Manual (Page 66)

67
Butler 2000
67 67 67 67 67 67 67
5.10.1 Activate Call Barring
• Press the Function button until “BASE SETTING”
is displayed.
• Press the OK button.
• Press the Function button until “BARRING”
is displayed.
• Press the OK button.
• On the display “FP PIN :” is shown (see 5.14
Change Master PIN code (base station)).
• Enter the PIN code and press the OK button. The
number that has already been registered appears on the display : “NO 1 : XXX”.
• If no number has been registered, “EMPTY”
is displayed.
• Enter the number and press the OK button.
The number can be erased or corrected by pressing the Erase button .
• When “HANDY : “ is displayed, enter the handset numbers one by one.
• Press the OK button and the unit returns to the “BARRING” menu.
5.11 Direct Call (Babycall)
This function allows you to program one specific number that will be dialled
automatically no matter what key has been pressed. One direct call number can be
programmed per handset. Incoming calls can still be answered without a problem.
5.11.1 Activating a Direct Call number
• Press the Function button until “DIRECT CALL”
is shown on the display. Press the OK button.
• Enter the desired telephone number. The number
is shown on the display and can be corrected by
pressing the Erase button , if necessary.
• Press the OK button, this function is activated.
• When the number has not been entered,
”PHONE NUMBER” appears on the display.
• Enter the phone number, press the OK button
and you will be connected with this number.
DIRECT CALL
0 9 1 1 2 0 0 1 0
PHONE NUMBER
BASE SETTING
B A R R I N G
FP PIN:
NO1: EMPTY