Tyco Electronics MM102014V1 - Manual (Page 20)

MM102014V1, Rev. G
Table 4-3: Basic Menu Structure
Menu Name
Radio Displays
(top and bottom lines)
Usage Notes
To/From Dwell Display
▲ ▼
registration, RF sync and
transceiver status codes
Engineering
Display
(Menu may not be avail-
able per programming.)
bit-error rates
and RSSI data
Displays radio system connection data.
For engineering use. See page 54.
▲ ▼
OFF/ON
Silent Emergency
“SilentEmerg”
Use ◄ or ► to toggle between OFF/ON.
Press Select to enable.
▲ ▼
current latitude and
longitude (degrees:-
minutes:seconds)
GPS Fix
(e.g. GPS, Aged, Site)
“GPS”
Radio’s current GPS latitude and
longitude position scrolls across top line
of the display. Applies to GPS-equipped
radios only. See page 48.
▲ ▼
User ID # of user currently
logged in User ID
“User ID”
User’s identification/name scrolls across
top line of the display (if programmed).
▲ ▼
Radio’s IP address
IP Address
“IP Address”
Radio’s Internet Protocol (IP) address
scrolls across top line of the display.
▲ ▼
station’s call sign
Station
Identification “Station ID”
Station’s identification/name scrolls
across top line of the display (if
programmed).
▲ ▼
V-TAC operating mod e V-TAC Mode
(e.g., XCOV,
XCOV-TG, SOI)
“Vmode Menu”
Use ◄ or ► to turn choose an available
V-TAC operating mode. See page 48.
▲ ▼
V-TAC SOI channel
V-TAC Channels
(Menu appears only if in
SOI mode.)
“Vchan Menu”
Use ◄ or ► to turn choose an available
V-TAC channel for Scene-Of-Incident
(SOI) mode communications. See pages
48 and 52.
▲ ▼
available modes
Operating Mode
(e.g., OTP, OCF) “Mode Menu”
Use ◄ or ► to turn choose an available
mode. Press Select and confirm (Y/N)
with ◄ or ► and Select again.
▲ ▼
“OFF” Stealth Mode
(blanks display when on) “StealthMenu”
Use ◄ or ► to turn on. Press any button
to turn it off. See page 23.
▲ ▼
“LOW”, “MEDIUM”,
“MEDHIGH”, “HIGH” Treble Level
“Treble Menu”
Use ◄ or ► to choose speaker/headset
treble level. Press Select to return to
dwell display. See page 31.
▲ ▼
“<< >>”
Display
Brightness “Bright Menu”
Use ◄ to dim and ► to brighten
backlighting. Press Select to return to
dwell display. See page 23.
▲ ▼
“OFF”, “LOW”, “MED”,
HIGH” Side Tone Level
“Side Menu”
Use ◄ or ► to choose side tone level.
Press Select to return to dwell display.
See page 24.
▲ ▼
“ON” or “OFF”
Intercom
“INTERCOM”
Use ◄ or ► to turn intercom on and off.
Press Select to return to dwell display.
See page 32.
▲ ▼
selected channel Selected Channel
(Menu may not be
available per radio
programming)
“ChannelMenu”
Displays the current channel. Press
Select
to return to dwell display.
▲ ▼
See Next Page
20