Tyco Electronics MM102014V1 - Manual (Page 59)

MM102014V1, Rev. G
Table 6-1: Monitor Modes
MONITOR
MODE
EXPLANATION
MONITOR
P25 Channels: Will play received voice regardless of Network
Access Code (NAC), Talk Group ID (TGID), or Destination ID
(DESTID).
Analog Channels: Will play received voice regardless of CTCSS
tone detection.
NORMAL
P25 Channels: Will play received voice if the NAC of call matches
that specified for the selected channel.
Analog Channels: Will play received voice if the CTCSS tone of the
call matches that specified for the selected channel.
SELECT
P25 Channels: For Group Calls, will play received voice if the NAC
and the TGID of call matches that specified for the selected channel.
For Individual Calls; will play received voice if the NAC of call
matches that specified for the selected channel and the DESTID of
the call matches the SOURCEID of the radio.
Analog Channels: Will play received voice if the CTCSS tone of the
call matches that specified for the selected channel (Identical to
NORMAL mode).
6.5.1 Setting Monitor Mode
1. Press ▲ or ▼ button until Monitor mode menu appears (Monitor, Normal, or Select).
2. Use the ◄ or ► button to cycle through the list of modes until the desired mode is displayed.
3. The radio will return to the Channel menu after a few seconds. Monitor mode has been changed.
6.5.2 Duration of Monitor Mode Selections
Monitor Mode selections survive power down.
To save the current Monitor mode without powering down the radio, reboot the radio from
the OCF mode to any mode (including the OCF mode) using the “Sel to Load” menu. The
following settings will be saved: Monitor mode, RSSI squelch control, RSSI squelch
level, side tone control and brightness.
59