Telit Wireless Solutions Easy GPRS - Manual (Page 13)

Easy GPRS User Guide
80000ST10028 Rev. 1 - 14/03/07
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 13 of 37
<precedence> - is the precedence class
<delay> - is the delay class
<reliability> - is the connection reliability class
<peak> - is the peak data transfer throughput
<mean> - is the mean data transfer throughput
Parameters assume the same values as in the previous section.
• wait for response:
Response Reason Action
OK context parameters have been
successfully stored
proceed ahead
ERROR some error occurred check parameters and retry
For example:
1- Let's assume you want to set-up the GPRS context number 1(cid) written before with your GPRS
requested QoS parameters:
Precedence class: High priority
Delay class: subscribed
Reliability class: subscribed
Peak throughput: subscribed
Mean throughput: best effort
command:
AT+CGQREQ= 1,1,0,0,0,31 <cr>
response
OK
NOTE: Telit suggests to setup AT+CGQMIN=1,0,0,3,0,0