Preparation of the remote control – Toshiba HD-XA2KN User Manual

Page 16

Advertising
background image

16

1

Chapter

1

Introduction

Notes

Do not drop or give the remote control a shock.
Do not leave the remote control near an extremely hot or humid place.
Do not spill water or put anything wet on the remote control.
Do not disassemble the remote control.
Dispose of batteries in a designated disposal area.
Batteries should always be disposed of with the environment in mind.
Always dispose of batteries in accordance with applicable laws and regulations.
If the remote control does not operate correctly, or if the operating range becomes reduced, replace all batteries with

new ones.

When necessary to replace batteries in the remote control, always replace all batteries with new ones. Never mix

battery types or use new and used batteries in combination.

Be sure to use AAA size batteries.
Always remove batteries from remote control if they are dead or if the remote control is not be used for an extended

period of time. This will prevent battery acid from leaking into the battery compartment.

Caution

Never throw batteries into a fi re.

Point the remote control at the remote sensor and
press the buttons.

Distance : About 7 m (23 ft) from

the front of the remote
sensor

Angle

: About 30° in each

direction of the front
of the remote sensor

Open the cover.

Insert batteries.

7 Use 4 batteries (AAA sizes).
7 Make sure to match the + and – on the batteries

to the marks inside the battery compartment.

Close the cover.

1

1

2

2

3

3

Set up the remote control to operate the player and your TV.

Preparation of the remote control

Loading batteries

Operating with the remote control

The remote control has a backlight function for

conveniently illuminating the buttons when you use the

remote control in a dark room, etc.

Lights for approximately 10 seconds when a button is

pressed.

The backlight function is off by default.

About the remote control backlight

To turn on the backlight function

Press and hold

for at least three

seconds.

To turn off the backlight function, press and hold

again for at least three seconds.

Notes

Using the backlight function shortens the lifespan of

the batteries.

The backlight function turns off if the batteries in the

remote control are replaced.

HD-XA2KN_01_E.indd 16

HD-XA2KN_01_E.indd 16

06.12.5 0:22:58 PM

06.12.5 0:22:58 PM

Advertising
This manual is related to the following products: