Toshiba W-808 - Manual (Page 21)

21
PLA
YB
A
C
K
Adjusting the tracking
When playback starts, the VCR
automatically adjusts the tracking for clear
pictures and sound (Digital Auto Tracking).
The “DT” indicator blinks during the
adjusting.
If the VCR cannot locate the best possible
tracking point, hold down one of
CH/TRK to
adjust the tracking manually.
• To resume the digital auto tracking, hold
down both CHANNEL on the VCR
simultaneously for about 2 seconds.
Notes
• During the adjusting, the playback picture and
sound may be distorted.
• The digital auto tracking is activated only in the
playback mode.
• To reset the manual tracking point to the center,
press both CHANNEL on the VCR
simultaneously for not longer than 1 second.
• The noise on the screen may not be completely
eliminated depending on the tape used,
especially when the tape was recorded on
another VCR.
DNR (Digital Noise Reduction)
(For W-808 only)
The noise reduction function of this VCR is based
on a digital signals system utilizing memory. It is
effective in the playback of noisy tapes as well as
S-VIDEO and RF in video signal.
Furthermore the CSE (Color Signal
Enhancement) circuit, which is included in the
system, compensates for color signal weakness
and gives the best possible color. Thanks to this
circuit color distortion is reduced and a sharp
picture is played back.
Press DNR repeatedly to select the following:
D
n
R O
n
: Usually set to “O
n
”.
The “D
n
R O
n
” will appear on the TV
screen and you can view the picture
with less noise.
D
n
R OFF: This function will not work.
Notes
• The DNR playback is available only in the
playback mode.
• Depending on the recorded picture, for example
too vivid or too noisy, you may not notice a
reduction in the noise.
• The noise reduction may not work on pictures
recorded from special equipment such as TV
game machines or computers.
• The picture sharpness can be changed by full
screen OSD setting. (See page 16.)
Basic Playback
1
Load a recorded cassette.
Power is turned on.
If the cassette has no safety tab,
playback starts automatically.
2 Press PLAY/x2 to start playback.
3
To stop playback, press STOP .
Rewinding / Fast-forwarding
Press REW or FF in the stop mode.
POWER
PLAYBACK
Playback
This VCR can also play back a tape recorded in S-VHS or S-VHS ET format. This section explains the
basic playback operation.
Preparation
• Select the video channel (3 or 4) or video input mode on the TV.
• Press
VCR to set the remote control operating the VCR.
VCR S P
DT
POWER
A.SELECT REMAIN COUNTER COUNT
RESET
POWER CH DOWN CH UP
DNR
2 1 3
5 4 6
8 7 9
0 100
PLAY/x2
ENTER
STOP
VCR Plus+
REW FF
VCR
CH/TRK
FF
3
DNR
REW
2
(Continued)