Toshiba SD-5915SC - Manual (Page 46)

46
Others
Operating a TV with the Remote Control
You can operate the basic functions of selected TVs using the
supplied remote control
Operating a TV with the remote control
Preparation
Follow the instruction of “To program the remote control” to set the brand code.
Point the remote control at your TV, and use buttons
as follows.
To program the remote control
2 While holding down PROGRAM enter the two digits
of your TV’s brand code (listed on page 47) using
Number buttons.
e.g. To program brand code 01.
Note
When using the remote control, press the buttons at intervals
of about 1 second to ensure the correct mode of operation.
3 Release PROGRAM.
The DVD remote control memorizes the selected TV brand
code.
POWER To turn the TV on or off.
INPUT SELECT To select external source such as a
VCR.
NUMBER buttons To select TV channel. When selecting
channels 1 to 9, first enter 0 and then
the desired number.
100 To substitute for 100 channel key.
• DISPLAY To turn on or off TV’s screen display.
VOL + / - To adjust the volume.
CH +/ - To select a channel.
ENTER To use for the TV’s ENTER key.
Notes
• The remote control is programmed at the factory to
operate TOSHIBA TVs.
• A single brand may use different codes depending on the
particular model. Enter the correct number referring to the
brand code table.
• For some brands, several brand codes are provided. Try
each of them until the remote control operates your TV.
• Some TVs may not respond to all of the functions in the table
above, or may not be operated at all with this remote control.
• If you replace the remote control’s batteries, remember to
reprogram the brand codes for TV.
• Press DVD back if DVD operation is required.
POWER
INPUT SELECT
Numbers/100
CH, VOL
ENTER
• DISPLAY
PROGRAM
1 Press TV to select TV mode.
0
PROGRAM
1