T+A Elektroakustik DD 1535 R - Manual (Page 46)

46
Digital SAT receiver (set-top box)
The components of your system should be connected as
shown in Wiring Diagram 5. This is the procedure:
• If the set-top box features an optical digital sound
output, connect it to the digital input
(DIGITAL INPUT 1 or 2) of the DD 1535 R using an
optical cable.
Note:
Set-top boxes with a co-axial digital output can be
connected to one of the (Cinch) digital inputs
3 . . . 5.
• Use an S-Video cable to connect the S-Video soc-
kets on the set-top box to the S-Video input sockets
of the DD 1535 R.
Note:
Instead of a set-top box, any other AV source device
can also be connected to the SETTOPBOX input in
the same manner.
If the set-top box only features SCART connections,
please use a SCART / S-Video adaptor cable to
connect the system components.
• Finally connect the equipment to the mains supply
and switch the system on.
• Settings in the 'Inputs Menu':
The digital sound signal of the set-topbox is
connected to the optical digital input DIG-1 on the
SR 1535 R
; to cater for this you should add the name
STB as a suffix to DIG-1.
• In the 'Video Input menu' select the type of video
signal (in this case S-Video) for the appropriate input.
Selecting the source device settopbox in normal use:
• The source button     on the front panel or the
remote control button of the same name selects the
settopbox
as current surround viewing and
listening source .