Tekkeon ET3000 - Manual (Page 6)

4
Setting Up ezTalker digital
Before using ezTalker digital, you must:
• Charge ezTalker digital
• Pair ezTalker digital to your mobile phone
• Adjust ezTalker digital to your ear preference
Directions for each of these activities are provided in the following three sections. Once these steps are
completed, you will be ready to use ezTalker digital!
Charging ezTalker digital
Before using ezTalker digital, you must charge the headset for a minimum of two hours. When fully
charged, the battery provides up to five hours of talk time and up to 120 hours of standby time.
The battery status icon, and a beep heard every 32 seconds will indicate a low battery (less than 10%
of capacity).
To Charge the Headset
1. Plug the power adapter into the charging jack on the side of the earhook.
2. Plug the power adapter into a wall outlet. The green charging LED on the
headset will light while the headset is charging. When the headset is fully
charged, the battery icon will indicate full and the green LED will
turn off.
3. Unplug the power adapter from the wall outlet and the headset.
NOTE: The battery can be charged when the earhook is either connected to or
disconnected from the headset.