Tandberg Data T40 - Manual (Page 42)

34 Configuring the Library
Note
You cannot delete the default Administrator account. You can, however, change
the password.
Using the Setup Wizard
The Setup Wizard simplifies the process of configuring the library. When you first power on the library,
the front panel displays the Setup Wizard. As you work through the Setup Wizard screens, follow the
on-screen instructions.
The recommended procedure for using the Setup Wizard for the initial configuration is as follows:
1. Turn on the library and begin the Setup Wizard on the front panel. Be sure to configure network
settings.
2. When the Setup Wizard screen text prompts you to choose Local or Remote, you must choose to
complete the wizard either locally on the front panel interface or remotely on the remote
management interface.
3. If you choose to complete the wizard remotely, you must log in to the remote management
interface. Use the default Administrator account. The default User Name is Administrator, and
the default password field is blank.
4. Complete the Setup Wizard.
Details on using the Setup Wizard include:
You may choose to use the default settings that the Setup Wizard suggests, but you must confirm
the proposed settings and complete the Setup Wizard before you can begin using the library.
If you choose to complete the Setup Wizard remotely, the FPI wizard automatically displays the
Network settings you need to access the RMI.
If you run the Setup Wizard from the FPI and you do not complete all the Setup Wizard screens,
the library will save whatever modifications (if any) you have made. However if you run the Setup
Wizard from the RMI, you need to confirm that you want to save the setup.
You do not need to log in to the library from the FPI when the Setup Wizard appears on the front
panel the first time the library is powered on.
When you power-on your library for the first time, you can only configure network settings on the
front panel, and you cannot log in to the library from the remote management interface until you
have configured network settings.
You can always return to the Setup Wizard whenever you are logged in as Administrator to either
the front panel or the remote management interface.
Note
The setup wizard may need to reboot your library one or more times during setup
Setup Wizard Tasks
The Setup Wizard contains all configuration options. When you first power on the library you must
complete the Setup Wizard. When you later want to reconfigure the library you can choose to either
use the Setup Wizard or the individual configuration options found in the Setup menus.
This section includes an overview of the Setup Wizard configurations. The configurations are
described in detail in the following chapters.
Note
You may not see all the choices presented below when running the FPI Setup
Wizard. It routes you past choices that have become irrelevant because of
previous selections.
Example: If you select RMI DHCP mode, the Static IP address, netmask and
default gateway are irrelevant.