Tandberg Data T40 - Manual (Page 62)

54 Getting Status and Information
SCSI ID <value as applicable>
Fibre Channel ID <value as applicable>
Fibre Topology <value as applicable>
Fibre Channel Speed <value as applicable>
Assigned Partition <1, 2, 3, or 4>
Control Path <Enabled, Disabled>
Drive Serial Number (Drive SN): <value>
Drive Firmware Version (Drive FW): <value>
World Wide Name
World Wide Node Name
The following partition information is available from the Partitions/Drive report:
Partition Number
Control Path <No or Yes, Drive ID>
Status <online/offline>
Number of slots
Drive ID numbers for drives in the partition
Total number of cartridges
Barcode Mode <6 Character or 13 Character>
Autoclean <Enabled or Disabled>
The path to open the report from the RMI is Reports > Partitions/Drive Settings.
Viewing Network Settings
The Network Settings report provides information on the following library settings:
Network Settings Address mode (static or dynamic), IP address, subnet mask, gateway, and
MAC address
Notification SNMP server IP address, e-mail address, notification enabled or disabled,
notification severity
The path to open the report from the FPI or from the RMI is Reports > Network Settings.
Viewing Statistics
The Viewing Statistics report captures the statistics of the library.
Gets (Fetches)
Puts (Stows)
Power on Hours
Time since drive cleaning
The path to open the report from FPI or RMI is Reports > Statistics.