Technicolor - Thomson 42PB120S4 - Manual (Page 19)

Using the teletext
EN
19
Teletext offers some other useful functions:
Newsflash
When a newsflash is detected, PAT is replaced by N. Press the blue
button to display the newsflash. In the case of an update,Teletext is
automatically enabled and displays the new information.
To display the header and the navigation bar again, press any button
(except
EXIT , the button or the volume adjustment buttons) on the
remote control.
This function is cancelled when you change channels or put the set into
standby.
To return to TV mode, press EXIT .
Subtitles
Some channels provide subtitles for some of their programmes through
Teletext.The numbers of the relevant pages are specified on the Teletext
index page.
To display the subtitles, enter the number of the relevant page. Once it is
found, the subtitles appear in the TV picture.The header and the
navigation bar disappear after a couple of seconds.To display them again,
press any button (except
EXIT , the button or the volume
adjustment buttons) on the remote control.
To return to TV mode, press EXIT .
Alarm page
In some countries (Spain, Benelux, etc.), you can set a time to display
certain Teletext pages (alarm pages).
To do this, display the relevant alarm page and press the buttons to
enter subpage mode. Enter the time instead of the subpage number (e.g.
1705 for 17:05) and press
EXIT .The page will disappear and will appear
again at the set time, as long as you do not change channels or switch off
the set beforehand.
Fastext
If Fastext is available, direct access to previous and subsequent pages is
replaced with coloured bars (red, green, yellow and blue) which provide
links to the topics you can access by pressing the corresponding buttons
on the remote control.
Press the MENU button to access these direct links, press it again to
display the navigation bar.
Temporary change of the character set
You can temporarily change the character set.To do so, display the
navigation bar using the
MENU button, then press the OK button to
display the number of the current character set in place of ???.
Scroll the list of character sets using the green button. Press the OK
button to display the ??? function again.
The character set will reset to the one selected in the MANUAL
INSTALLATION menu:
- when the set is turned off or put into standby,
- when you change channels.
In Teletext mode, volume controls remain available, but the relevant
symbols do not display.
42pb120S4-en 2/07/04 11:32 Page 19