Teac SR-100I - Manual (Page 31)

31
EN
GL
IS
H
If you a have problem with your system, read this page and
try to solve the problem yourself before calling your dealer
or a TEAC service Center.
General
No power
e Check the connection to the AC power supply. Check
whether or not the AC source is a switched socket. If it
is, confirm that the switch is turned on.
e Confirm that there is power to the AC wall socket by
plugging another item such as a lamp or fan into it.
No sound from the speakers.
e Select the source by pressing the FUNCTION button.
e Adjust the volume.
e If “MUTE” blinks, press the MUTING button.
The sound is noisy.
e The unit is too close to a TV or similar device. Relocate
it away from the interfering device or turn it off.
e A fan for dispersing heat is built into the left side
of the main unit. Depending on the surrounding
environment, you might hear the sound of it rotating.
This noise is not a malfunction.
The remote control does not work.
e Press the Standby/On (
) button to turn the unit on.
e If the battery is exhausted, replace it with a new one.
e Use the remote control unit within the operation
range (16ft/5 m) and point it at the remote sensor on
the front panel.
e Remove obstacles between the remote control unit
and the main unit.
e If a bright light is near the unit, turn it off.
Power cannot be turned off (put in standby) when
using an iPod touch as the sound source.
e When using an iPod touch with this unit, if you use
any application other than the iPod application, the
SR-100i power might turn on again soon after it is
turned off (put in standby). Since the unit cannot turn
the iPod touch power off when such an application is
running, you must quit the application before turning
SR-100i off (putting it in standby).
The sound drops temporarily when changing the
volume from 6 to 7 or from 7 to 6.
e The sound drops for about a half second as the
operation of the internal circuit switches. This is not a
malfunction.
iPod Player
Cannot connect the iPod.
e Remove dust or obstacles from the dock connector of
SR-100i and the iPod, then connect the iPod again.
Cannot operate the iPod.
e Release the iPod HOLD switch.
Cannot play.
e Remove the iPod from the dock, wait a few seconds,
then connect it again.
e A software update might solve the problem. Visit the
Apple website and download the latest iPod software.
FM Tuner
Cannot listen to any station, or the signal is too
weak.
e Tune in to a station properly.
e Rotate the FM antenna until you receive the station
clearly.
CD Player
Cannot play.
e Load a disc with the label side facing you.
e If the disc is dirty, clean the surface of the disc.
e A blank disc may be loaded. Load a prerecorded disc.
e Depending on the disc, etc. it may not be possible to
play back a CD-R/RW disc. Try again with another disc.
e You cannot play back unfinalized CD-R/RW discs.
Finalize such a disc using a CD recorder and try again.
Troubleshooting (1)