Uniden UH015sx - Manual (Page 10)

Setting the Squelch
Turn the Unit ON by rotating the volume control clockwise. The uh015sx
has 3 preset squelch levels:
1 - max sensitivity (min squelch)
2 - med sensitivity (med squelch)
3 - min sensitivity (max/tight squelch)
It requires no adjustment.
Press and hold MON . The squelch will flash.
Turn rotary knob to select. Press MON to set.
The SQT icon appears if level 3 is selected.
! Selecting tight squelch mode may prevent the
reception of weak signals.
! High noise areas may still break the squelch.
UNIDEN Model uh015sx UHF CB Radio
Operation
9
Monitor
Press MON to open the
squelch and receive all
weak signals.
Press MON again
momentarily to cancel.
Selecting a Channel/POLICE and CB Channel Groups
Turn the Rotary Channel Selector to select the desired channel.
The uh015sx has two groups of channels to select from. When the CB icon is showing
the 40 UHF-CB and any user programmed RX channel will be available for selection or
scanning. When the POLICE icon is showing then the 115 police frequencies will be
available. Press POL to select which group(s) to activate or deactivate.
For your reference a list of the
available UHF CB channels,
corresponding frequencies and
guidelines for their use is printed
on page 36. For Australia,
Channels 05 and 35 are
reserved for Emergency Calls.
The 40 UHF-CB channels are numbered 1-40. The programmable RX channels are
numbered 41-100 (100 is shown as o0) - and only show when programmed. The 115
police frequencies do not have channel numbers but you can still select them ( - -
appears in the channel display) or copy them to a programmable RX channel.
MENU
ENTER
SCAN
OS/GS
SRCH
BAND/TSQ
MON
SQL
HOLD
DCS/CTCSS
POL
MEM
MENU
ENTER
SCAN
OS/GS
SRCH
BAND/TSQ
MON
SQL
HOLD
DCS/CTCSS
POL
MEM
MENU
ENTER
SCAN
OS/GS
SRCH
BAND/TSQ
MON
SQL
HOLD
DCS/CTCSS
POL
MEM