UTStarcom CDM-8625 - Manual (Page 15)

BASIC FUNCTIONS BASIC OPERATION
27
Call Waiting is a system dependent feature. Please contact
your service provider for details.
BASIC OPERATION BASIC FUNCTIONS
26
■ CALL WAITING FUNCTION
Notifies you of an incoming call when you are already on a call by
sounding a beep tone and displaying the caller’s phone number.
To answer another call while on the phone, press .
This places the first call on hold. To switch back to the
first caller, press again.
■ WAIT/PAUSE FEATURE
Pauses are used for automated systems (i.e., voice mail, calling
cards). Insert a pause after a phone number then enter another
group of numbers. The second set of numbers is dialed
automatically after the pause. This feature is useful for dialing into
systems that require a code.
To insert a pause, enter a phone number then
press [MENU]. Select either a Hard Pause
(“P” appears) or a Timed Pause (“T” appears).
Press to dial or [SAVE] to store.
Please refer to page 32 for more details about
storing a phone number.
NUMBER
Select
“P”or”T”
OR
■ ADJUSTING VOLUME
To adjust the volume of the ringer, key beep and speaker:
Select one of the following:
Adjust volume and press to save it.
• Ringer: Controls the ringer volume.
• Key Tone: Controls the key pad tone.
• Voice Call: Controls the earpiece volume.
• Speaker Phone: Controls the speaker volume.
• Move the to adjust volume of earpiece during
a call.
• To adjust the master volume, press the up or down Side
Volume keys.
ᕢ
ᕡ
ᕡ
ᕢ