UTStarcom CDM-8625 User Manual
Page 8
BATTERY USAGE
BEFORE USING
■ BATTERY INSTALLATION
As shown in the picture below, place the metal locators of the
battery into the holes located in the bottom of the unit.
Place the battery on the back of the handset and
slide into place.
Push the battery down until it locks into place.
13
If the battery is not correctly placed in the compartment,
the handset will not turn on and/or the battery may detach
during use.
BEFORE USING
DISPLAY INDICATORS
12
Etiquette
Phone will vibrate when call is received.
Schedule
Appears when either an event or an alarm is set.
Dormant
Indicates your phone is in a dormant state during a
data call. Your phone lapses into Dormant mode when
you have no activity on a page for some time - your
connection is still active and now you can make and
receive calls.
Data Only
Phone is ready to receive a data call.
GPS Icon
Indicates the Location Service of your phone is
disabled/enabled.
Scratch Pad
Displays when scratch pad is in use during a call.
1X Service
Indicates the phone is in the 1x service area.
Ring Mode
Appears when a ringer is set for the
ringer mode.
■ BATTERY REMOVAL
Pull down the release latch, lift up the battery.
Remove the battery from the handset.
ᕡ
ᕢ
ᕢ
ᕡ