Uniden ENR1504 - Manual (Page 13)

25
Figure 3 Account Configuration Screen
2. Change the Administrative Login Name and
Administrative Password. Make a note of the login name
and password in the memo section of this manual (page
109).
3. Click Apply. If the router displays a dialogue box that says
“Values are saved. Do you really want to reboot the system
now?” click Cancel. We will reboot the router after all the
changes are made.
NOTE: The new name and password will take effect when
you reboot the router.
CONFIGURING THE TIME
1. In the menu on the left of the screen, click on System
Administration and then Time Information Setup. This
displays the Time Information Setup screen (Figure 4).
26
Figure 4 Time Information Setup Screen
2. In the Timezone field, select the time zone you are in.
3. If you want to enable the Network Time Protocol on the
router, select Enable in the NTP field. NTP is an Internet
protocol standard that will be used to synchronize Routers
clock to an internet based NTP server such as the U.S.
Naval Observatory Master Clocks in Washington, DC and
Colorado Springs CO.
4. If you enable NTP, enter the NTP Server URL, or select an
NTP server from the NTP Server List.
5. If you want your router to recognize Daylight Savings Time,
select Enable in the Daylight field.
6. Click Apply. If the router displays a dialogue box that says
“Values are saved. Do you really want to reboot the system
now?” click Cancel. We will reboot the router after all the
changes are made.