Ultra electronic MAGICARD 300 - Manual

www.ultramagicard.com
300 & Sprinter dye-film installation guide
To remove the dye-film carrier turn the “Dzus”
fastener ring a quarter turn counter-clockwise,
the dye film carrier can then be removed.
1
Remove the roll of dye film from its wrapper
and slide it over the bottom feed core.
Also fit an empty take up roll over the top core.
Important:-
Ensure the two locating notches are facing to
the left on both the top and bottom rolls, as
shown in diagram right>>>.
2
Notches
Replace the Film Carrier, with the empty take up
spool facing the top.
3