Resetting handsets – Uniden D3280 User Manual
Page 23
English -
Bluetooth problems
Possible solutions
The D3280 won’t pair with
my phone.
Making sure your phone is in pairing mode.
Check your phone’s manual for instructions on Bluetooth
device pairing.
Making sure your phone supports the Bluetooth hands-free
profile.
Checking the link order for that phone. In rare cases, some
cellular phones may not be linked as the third or fourth
cellular phone.
The D3280 doesn’t ring
when my cellular phone
does.
Making sure your phone has Bluetooth turned on.
Making sure your phone is in range of the base.
Making sure the handset’s ringer is not turned off. (The base
doesn’t ring on cellular calls.)
The D3280 paired with
my phone, but I can’t hear
anything through the
handset.
Adjusting the handset volume.
Setting your cellular phone to transfer the audio to
a Bluetooth device. Check your phone’s manual for
instructions on Bluetooth setup and options.
Erase the Bluetooth pairing and repair the cellular phone to
the base. To erase the Bluetooth pairing, see p. 11.
Installing a Line Filter or DSL Filter
A telephone line filter or DSL filter prevents services that use the phone line from
causing interference on your phone. To get a line filter, contact your service provider
or look in an electronics store.
Plug the filter into the telephone wall jack and plug the base into the filter. Make a
test call to make sure the noise is gone.
Liquid Damage
CAUTION: If the base is covered in liquid, disconnect the adapter & phone
cord from the wall before touching it.
If the liquid is only on the exterior housing of the base or handset, wipe it off and
use as normal. If you can hear liquid inside the housing:
Remove all compartment covers, and disconnect all cables and cords.
If liquid is leaking from any vent or hole, turn the phone so that vent faces down.
If not, place the largest vent face down.
Let dry for at least 3 days. Check for liquid inside the phone before replacing
compartment covers & reconnecting cords.
Resetting Handsets
If you have trouble with a handset or if you want to replace one, clear the
registration information from the base and the handset:
Press & hold
end
and
#
at the same time until you see the
System Reset
menu.
1.
2.
3.
1.