Uniden D3280 - Manual (Page 24)

 - English
If you still have the base the handset is registered to, select Deregister HS , then
select the handset you want to reset. If you don’t have that base anymore, select
Base Unavailable .
To confirm, select Yes . The handset displays Handset not registered .
Registering Handsets
If you see a “not registered” message on a handset, you must register it to a base
before using it.
Place the handset in the base; the display should say Handset Registering .
Wait until the display says Registration Complete (about 30 seconds), then pick up
the handset; press Home/FlasH .
If you don’t hear a dial tone or the display says Registration Failed , charge
the battery completely, then try again.
2.
3.
1.
2.

Adapter and Battery Information
AC adapter Base Charger
Part number PS-0034 PS-0035
Input voltage 120V AC, 60 Hz
Output voltage 7.8V AC @
450mA
8V AC @
300mA
Use only the supplied AC adapters.
Use the proper adapter for the base & any
chargers.
Do not place the unit in direct sunlight or subject
it to high temperatures.
Battery pack (with normal use)
Part number BT-1022
Capacity 300mAh, 2.4V DC
Talk time about 7 hours
Standby time about 7 days
Battery life about 1 year
Replace the battery when the talk or standby time
becomes noticeably reduced. For replacements,
call the Parts Department (see the front cover).
When the battery gets low, the handset beeps and
shows a low battery alert; put the handset in the
cradle for recharging.
Rechargeable Battery Warning
This equipment contains a rechargeable Nickel-
Metal-Hydride (Ni-MH) battery.
Nickel is a chemical known to the state of Califor-
nia to cause cancer.
Do not short-circuit the battery.
The batteries in this equipment may explode if
disposed of in a fire.
Do not charge the batteries in any charger other
than the one specified in the owner's manual.
Using another charger may damage the battery or
cause it to explode.










As part of our commitment to protecting our
environment and conserving
natural resources, Uniden
voluntarily participates in
an RBRC® industry program
to collect and recycle used
Ni-MH batteries within the
United States. Please call
1-800-8-BATTERY for
information on Ni-MH
battery recycling in your area. (RBRC® is a
registered trademark of the Rechargeable Battery
Recycling Corporation.)
Rechargeable batteries must be recycled or
disposed of properly.
Warning! The cords on this product and/or
accessories contain lead, a chemical known
to the state of California to cause birth
defects or other reproductive harm. Wash
hands after handling.
Uniden works to reduce lead content in our
products & accessories.
Compliance Information
FCC Part 68 Information
This equipment complies with Part 68 of the FCC
rules and the requirements adopted by the ACTA.
On the bottom of this equipment is a label that
contains, among other information, a product
identifier in the format US: AAAEQ##TXXXX.
If requested, this number must be provided to the
phone company.
An applicable Universal Service Order Codes
(USOC) certification for the jacks used in
this equipment is provided (i.e., RJ11C) in the
packaging with each piece of approved terminal
equipment. A plug and jack used to connect this
equipment to the premises wiring and telephone
network must comply with the applicable FCC
Part 68 rules and requirements adopted by the
