Uniden MHS135DSC - Manual (Page 5)

E-1 Uniden MHS135DSC Radio Owner’s Manual
Returning a call from the
Receive Log ..........................E-22
Test Calls .................................... E-22
Making Test Calls (Test) ...........E-22
Receiving Test Call Setup ..........E-23
Acknowledging Test
Call Receipt............................E-24
Position Request and Reply ........ E-24
Enabling Automatic
Position Reply ........................E-24
POS Request.............................E-24
Position Reply............................E-25
Position Send ...........................E-25
Putting the radio into standby .... E-25
Disabling automatic channel
switching ..................................... E-26
GPS Features ............................ E-26
GPS Operation Overview ............ E-26
Favorites Menu ............................ E-26
Goto Menu .................................E-27
Add Menu ..................................E-27
GPS Setup Menu ......................... E-27
NMEA Features ......................... E-28
ADDITIONAL FEATURES ......... E-28
Using the Flashlight .................... E-28
Renaming Channels .................. E-29
Maintenance and
Troubleshooting .................... E-29
Specifications ........................... E-30
Regulations and
Safety Warnings .................... E-36
Three Year Limited Warranty ... E-38
intrODUCtiOn
FeatUres
Your radio provides the following key features:
x Submersible design. Complies with floating JIS8/IPX8 water-resistant standards,
which means the radio can be submerged in 1.5 meters of water for 30 minutes
without damage.
# notes:
The radio will only meet this rating if fully assembled and all rubber seals and
bungs are well maintained and correctly fitted. This means that the speaker
microphone bung is inserted, and the battery pack (or case) and antenna are
attached and securely fastened.
After your radio is submerged in water, the sound might be distorted. This
is because there is still water remaining in and around the speaker and
microphone. Just shake the radio to clear excess water, and the sound should
return to normal.
If your radio is exposured to salt water, clean it thoroughly with fresh water
and dry it before turning it on.
The charger is not waterproof.
x Memory scan mode. Lets you save channels to memory and monitor them in
quick succession.
x Transmitter power level select. Lets you boost the transmitter power from 1 W to
2.5 or 6 W for added transmission distance.
x Battery level display and low battery alert.